User`s manual

Crown Broadcast FME 350W to 2000W User Manual– 05/2013
Page 25
Crown Broadcast, a division of International Radio & Electronics Corporation 25166 Leer Drive, Elkhart, Indiana, 46514-5425 USA
Ph [phone]
4.2.4. MPX configuration
GO TO
-> S T E N C O D E R >
Press the “+” key until you see the ST Encoder menu.
Then press the “Enter” key.
1 ST ENCODER
-> M O / S T : S T E R E O
1 GO TO
MA I N ->CODER
Press once again the “Enter” key to set the audio type.
Select what you need using “+” and “–” keys:
 STEREO
 MONO
 MONO_L
 MONO_R
Selecting STEREO enables the internal 19 kHz; you will
therefore want to select MONO for an MPX input.
Confirm with the “Enter” key and press “+” until you see
this screen. When the CODER menu is selected, press
“Enter” to return to the list of menus.
GO TO
-> S T E N C O D E R >
GO TO
-> M O D U L A T I O N >
Press the “+” key until you see the Modulation menu.
Then press the “Enter” key.
1 MODU L A T I ON
->DEV MPX:127.2
1 MODU L A T I ON
->DEV PILOT:18.4
Browse through the Modulation menu using the “+” and “–”
keys to set the total deviation between 0 and 150 kHz,
Set the pilot deviation between 0 and 25.5 kHz.
For each of these values, use the “Enter” key to switch to
edit mode, the “+” and “–” keys to adjust values and the
“Enter” key to confirm.
1 GO TO
MA I N->MODULAT I ON
Press the “+” key until you see this screen. When the
Modulation menu is selected, press “Enter” to return to the
list of menus.