User`s manual

Crown Broadcast FME 350W to 2000W User Manual– 05/2013
Page 30
Crown Broadcast, a division of International Radio & Electronics Corporation 25166 Leer Drive, Elkhart, Indiana, 46514-5425 USA
Ph [phone]
4.4.3. Configuring the transmitter
Click the button
in the tool bar to access the transmitter configuration and display the ‘Easy
Config’ page.
Basic configuration can be managed on this single page:
 Power, frequency and RF on
 Input priority setting
 MPX configuration
 Input configuration
Default transmitter pre-accentuation is 50 µs. Depending on your country, you might need to switch it to 75
µs (in the United States, for instance). The pre-accentuation parameter is available in the Input Source
section.
4.4.4. Getting on air
1. Disable the RF using the front panel RF button.
2. Make sure the RF indicator LED is off.
3. Disconnect the load and connect the antenna to the transmitter RF output.
4. Enable the RF again using the front panel RF button.