Instruction manual

Networked PIP Series
page 2
Reference Manual
Crown Technical Support
1718 W. Mishawaka Rd., Elkhart, Indiana 46517-9439 U.S.A.
Phone: [phone] (North America, Puerto Rico and Virgin Islands) or 574-294-8200
Fax: [phone] Internet: http://www.crownaudio.com
FCC COMPLIANCE NOTICE
This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
CAUTION: Changes or modifications not expressly approved by the party responsible for
complicance could void the user’s authority to operate the euqipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING
TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT EXPOSE THIS
EQUIPMENT TO RAIN OR MOISTURE!
WATCH FOR THESE SYMBOLS. The exclamation point triangle is
used to alert the user to important operating or maintenance
instructions.
The lightning bolt triangle is used to alert the user to the risk of
electric shock.
This product complies with CISPR22 Emissions standard,
EN55103-1 Emissions standard, and EN55103-2 Immunity standard.
136763-7_4-08_networked_pip-series_reference_manual.fm Page 2 Monday, March 17, 2008 11:17 AM