Instruction manual

page 9
Xs Series Power Amplifiers
Operation Manual
2.6.3 Bridge-Mono Mode
Typical input and output wiring is shown in
Figure 2.10.
NOTE: Crown provides a reference of wiring pin
assignments for commonly used connector
types in the Crown Amplifier Application Guide
available at www.crownaudio.
OUTPUTS: Connect the speaker across the red
binding posts of each channel. Do not use the
black binding posts when the amp is being oper-
ated in Bridge-Mono mode.
IMPORTANT: Set the Bridge/Normal
switch to “Bridge.”
NOTE: In Bridge-Mono mode, only the
Channel 1 Level control is functional.
2 Setup
Figure 2.10 Bridge-Mono Wiring