Instruction manual

XTi2 Series Power Ampliﬁers

page 5

Operation Manual

Get Started

LOW 1+/–

HIGH 2+/–

Factory Preset #3: XOVER

Putting the ampliﬁer in XOVER mode

enables a 1.2kHz 4th order (24dB/

octave) ﬁlter that sends frequencies of

1.2kHz and below to Channel 1 output

and frequencies of 1.2kHz and above

to Channel 2 output. The XTi2 Series

ampliﬁers come pre-loaded with a

preset that makes it easy to conﬁgure the

ampliﬁer for this operation.

Before you get started ensure that you:

1. Connect signal source to Channel

1 ONLY using an XLR connector (the ampliﬁer inputs will automatically be put into Y

mode when selecting this preset).

2. Connector the speaker as shown.

a. Connect the speaker you wish to receive the low and mid frequencies (1.2kHz and below) to Channel 1

output using Speakon

, Banana Plugs, or bare wire.

b. Connect the speaker you wish to receive the high frequencies (1.2kHz and above) to Channel 2 output

using Speakon

, Banana Plugs, or bare wire.

Follow these quick steps to conﬁgure the ampliﬁer for “Crossover Mode”:

1. Push the “Set/Enter” button and you will see the word “Preset” ﬂashing.

2. Push the “Set/Enter” button again to enter the list of presets in the ampliﬁer.

3. Push the “Next/Down” or “PREV/UP” button until the screen displays “BIAMP”.

4. Push the “Set/Enter” button to conﬁrm your selection.

5. The display will now read “BIAMP” with the Y icon and XOV icon highlighted.