Installation Guide

Chelsea Wall Mounted Accessory Fitting Instructions

Thank you for purchasing this Croydex product. Please follow the fixing and care

instructions to ensure that your accessory is fitted safely and that it retains its high

quality finish. Please retain this leaflet for future reference.

Fixing Pack Contents

Long Fixing Screws x 2 (4) (Double Mounting)

Wall Plug X 2 (4) (Double Mounting)

Wall Fixing Bracket x 1 (2) (Double Mounting)

Contents supplied will vary depending on the product. The quantities shown above

in brackets are for double bracket fixings.

NOTE - The wall plugs supplied are for solid walls only; use appropriate

fixings for cavity walls

Tools Required

Drill Pencil

6mm masonry drill bit Spirit Level

6mm ceramic drill bit (optional) Small flat head screwdriver

Cross head screwdriver Tape measure

KEEP DIY TOOLS OUT OF THE REACH OF CHILDREN

Safety and Care Advice

1. Always take care when using an electric drill, particularly in the bathroom.

Always check for hidden cables and pipework before drilling. Always use a

residual current circuit breaker (RCCB) when using mains powered tools

and take extreme care if there is any water in the working area.

2. Always wear suitable eye protection when drilling.

3. If the product is to be fitted on a ceramic tiled wall, a ceramic drill bit should

be used. Do not drill mounting holes in the grouted area between tiles.

Mask the area around the hole with tape before drilling to prevent damage

to the tile.

4. Do not use the product as a grab bar.

Instruction for items with single and double mounting point:

WMA 032 R03 A5

1. Select position of product and mark its centre on wall. (Refer to Fig. 1 for

centre positions of double mounting items.) Centre the wall fixing

bracket over the mark and using it as a template mark the screw fixing

positions on the wall surface.

PAGE 1
Chelsea Wall Mounted Accessory Fitting Instructions Thank you for purchasing this Croydex product. Please follow the fixing and care instructions to ensure that your accessory is fitted safely and that it retains its high quality finish. Please retain this leaflet for future reference. Fixing Pack Contents Long Fixing Screws x 2 (4) (Double Mounting) Wall Plug X 2 (4) (Double Mounting) Wall Fixing Bracket x 1 (2) (Double Mounting) Contents supplied will vary depending on the product.
PAGE 2
. Drill the holes to a depth of 40mm in the marked positions using a 6mm masonry drill. If the product is to be fitted onto a ceramic tiled wall, a ceramic drill bit should be used. 3. Insert the wall plugs flush to the surface of the wall. If fitting to a tiled surface, the wall plugs should be inserted below the surface of the tile to avoid cracking. 4. Insert the screws provided through the wall fixing bracket and screw into the wall. Ensuring the wall bracket is level. 5.