Datasheet

ManualsBrandsCRU Manualschassis components6056-0000-0000

Rugged, Reliable, Mobile, Secure

1-800-260-9800 www.CRU-DataPort.com

Data Express DE75 ATA 133 Install Guide

Removable Ultra ATA133 Drive Enclosure

Drive Installation Overview

Receiving Frame Motherboard

Receiving Frame Motherboard (Rear View)

Receiving Frame Motherboard

DC Power Connector (P1): The Data Express uses a standard

4-pin DC Power Connector to accept DC power.

I/O Connector (JP1): The input/output connector provides a

standard interface for all IDE signals.

JP6 Header:

Master/Slave Setting (JP6 ID0 & ID1):

ID0: Jumper installed on Pins 1 & 2 (Factory Default) for

Master conﬁguration.

ID1: Jumper installed on Pins 3 & 4 for Slave conﬁguration.

Remote Drive Activity (JP6 RLED): Pins 17 & 18 are used for

remote drive activity.

Jumper (JP6 DDA): Factory-installed on Pins 15 & 16 - Do not

remove!

JP4 Option: Refer to the full version of the DE75i-A100 Manual

for further information.

Master/Slave Drive Selection

There are two (2) ways to set the Master/Slave drive designation

for the DE75i-A100 unit.

Method 1 (Recommended)

Using the factory-installed jumper on your IDE drive

In most cases, the drive will be factory-conﬁgured as a Master

Ultra ATA133 drive using a jumper plug on the drive itself. No

conﬁguration changes are required. For multiple drive conﬁgura-

tions, it is necessary to set the ﬁrst IDE drive as Master and the

second IDE drive to Slave. This can be done by changing the

jumper on the Ultra ATA133 drive itself (refer to your drive manu-

facturer documentation).

This method requires no additional conﬁguration of the drive car-

rier circuit board.

Drive Installation Overview

Drive

Carrier

#6-32 x 3/16

Flat HD Screw

(6 Total)

I/O Cable

Drive

(Not Included)

Protective

Drive Cover

(Provided)

Power Cable

Receiving Frame

Motherboard

DC Power

Connector

I/O Connector

JP4 Option

Jumper (Do not remove)

ID0

}

Master/Slave

ID1

Conﬁguration

= Pin 1

Summary of content (2 pages)

PAGE 1
Rugged, Reliable, Mobile, Secure TM Data Express DE75 ATA 133 Install Guide Removable Ultra ATA133 Drive Enclosure Drive Installation Overview Protective Drive Cover (Provided) Drive Installation Overview Drive (Not Included) I/O Cable JP6 Header: Power Cable Drive Carrier Master/Slave Setting (JP6 ID0 & ID1): ID0: Jumper installed on Pins 1 & 2 (Factory Default) for Master configuration. #6-32 x 3/16 Flat HD Screw (6 Total) ID1: Jumper installed on Pins 3 & 4 for Slave configuration.
PAGE 2
Rugged, Reliable, Mobile, Secure TM Note: The lock on the Data Express serves as a power switch. It must be engaged (turned counterclockwise) for the Data Express to power up and function properly. However, the appropriate jumper setting must still be configured on JP6 (ID0 & ID1) located on the receiving frame motherboard (Figure 2). For Master setting, install jumper on ID0 (Pins 1 & 2). For slave setting, install jumper on ID1 (Pins 3 & 4).