Owner`s manual

TM gmn-ator controls turn the generator on and ofT. The BLOWERS
switch
operates the bilge blowers. Flip the switch up to operate the bilge
blowers. Before
attempting to start the generator, the bilge area must be
purged of all fumes. Operate the blowers for at least 4 minutes.
The STOP switch interrupts current to the generator . Turn the START
switch
on to star t the generator . Release the START switch when the
GENERATOR RUNNING indicator lights.
The ON / PREHEAT switch is used only on diesel generators .
OPERATION
OF AC SYSTEMS
Read through the table below to familiarize yourself with the AC systems
on your boat.
AC Swi«h
DOCKSIDE I
Function
A
CAlmON
Do not tum on tJu ~ for shore P""'" if tIu
revene poi<lrity indicnlm" ligha up. Disconned the
cable and ha"" tJu fault aJrTeCted by a quaIifird
ekctrician.
""'hen you are running dockside power to the dockside I power hookup, move the
slide protector
O\'er the GE!'\ERATOR breaker on the AC Power Control panel. Flip
the DOCKSIDE I breaker
(0 the 'on" position to send current to (he AC POWER
NO . I and AC POWER NO. 2 panels. When this switch is in the "orr position, the
flow of current to the panels is interrupted. When dockside 1 current is pr esent, the
DOCKSIDE 1 POWER indicator will illuminate.
A
WARNING
Some marinas have bem knoun to "?nm,k" shore
power
ground circuits to prevent ekctrolysis. opening
the ground circuit creak> a potentially dang""'us 00-
board shock ha=nrd. Ensure that your shore power
roble ground circuit
is always rontinuous.
Comucting Shore pOwa' cabk:
1. Make sure the ",.aka JOT load group ~ng ronructed is in tM 'ofr position.
2.
umneel short POW<'T cabu at the boat reuptack and then at the shure reuptacu .
3. When disconnect
ing shart power cabk turn the "'eaka Jm-load group ~ng disconntcted
to
tM 'ofT position.
4. DjJ conn ~Cl shUTt pOwn' cablr from flu shou r~aplack, and tkn from the boar receptacle.
4-9
Downloaded from CruisersOwnersForum
http://www.CruisersOwnersForum.com