Owner`s manual
AC Switch
GENERATOR
DOCKSIDE
2
GENERATOR
AC POWER
NO.1
STOVE
MICROWAVE
BATTCHGR
WATER
HEATER
Function
When
you are
going
to
run
AC
POWER NO. I systems
off
the
generator, move the
slide protector located on
the
AC POWER NO. I systems
off
the generator, move the
slide protector
located
on
the
AC power control panel to lock the DOCKSIDE I
breaker
in the
'off'
position.
Start
the
generator
and
flip the GENERATOR breaker
to
the
'on"
position.
Current
is
now
being
sent to the AC POWER NO. I panel.
Read the
generator
owner's
manual
before operating
the
generator.
When
you are
running
dockside
power
to
the dockside 2 power hookup, move the
slide protector over
the
GENERATOR breaker
on
the
AC
POWER
NO.2
panel. Flip
the DOCKSIDE 2
breaker
to
the
'on"
position to send
current
to
the
AC POWER
NO.2
panel. When this switch
is
in
the
'off'
position, the flow
of
current
to
the
AC
POWER
NO.2
panel
is
interrupted
. When dockside 2
current
is
present, the DOCK-
SIDE 2 POWER indicator will illuminate.
When
you
want to
run
the AC Power
No.2
panel
off
the generator, move the
protective slide over the DOCKSIDE
2 breakers. Start the generator
and
then
flip the
GENERATOR breaker on
the
AC Power
No.2
panel to the "on" position.
Current
is
now being sent to the
AC
Power
No.2
panel.
This
is
the master switch for
the
AC Power No.1 panel.
Put
the switch
in
the
'on"
position to send
current
to all circuit breakers on this panel. When this switch is
'off", the
flow
of
current
is
interrupted
to all circuit breakers
on
the panel.
The
POWER AVAIlABLE indicator will illuminate when
current
is
supplied to
the
AC
POWER NO.
I master switch.
Flip this switch to the "on" position to
send
current
to
the stove.
Move
the
switch
to
the
'off'
position to
interrupt
the
flow
of
current
Refer to the owner's manual for
operating inslructions.
Flip this switch
to
the
"on·
position to
send
current
to the microwave. Move
the
switch
(0
the
"ofT"
position
to
interrupt
the flow
of
currenL Refer
(0
the owner's
manual for operating instructions.
Flip the switch to the
"on·
position to
turn
the battery
charger
on.
The
battery
charger
provides for automatic battery charging.
It
converts shore power
or
genera-
tor
AC
power to
12
volts
DC
and
distributes the charge automatically to all
the
batteries according to
need
. Move the switch to the "off" position to
turn
the
charger
off.
Flip
the
swiLch
to the
"on"
position to (urn the water
healer
on
.
The
,"rater
healer
is
controlled
by
thermostat to
keep
lhe
water at a
constanllemperalure
.
Move
the
switch
to
the "otr' position
to
turn the water heater ofr. Never
tUfn
on
the
water
heater
without water in
the
heater
to
avoid damaging the heating
element.
4-10
Downloaded from CruisersOwnersForum
http://www.CruisersOwnersForum.com