Owner`s manual
~~
(
SCOPE
/
6T07TIMES
L
DEPTII
OF
WATER
~
-
-
CSRl62ยท7
To weigh (pull
in)
anchor,
it is
recommended
to have
the
engines
run-
ning. Pull in the
scope
until
the
line
is
vertical. Pull
hard
to
lift the
anchor's
shank
and
free
the
flukes from the
bottom
material.
If
the
anchor
is
stuck, attach
the
vertical, taut line
to
the
bow cleat. Wave
action
on
the
bow may lift flukes from
the
bottom
.
If
the
anchor
is still
stuck, feed
out
a few
feet
of
line
and
attach
it to bow cleaL
Maneuver
the
boat
around
the
anchor,
keeping
the
line
tighL Find
an
angle
that
,,;11
pull
the
anchor
loose.
Towing
the
Boat
A
CArmON
Do not use chck
hardware
for
grounding
and
rowing!
The stress may
be
too much
for
deats
and
mounting
plates.
Ckau
are
designM
for
mooring use only.
If
you are
aground,
need
a lOW,
or
wish to tow
another
craft,
use
great
care.
The
boat
structure
can
be
damaged
by excessive
pulling
strain.
Use a double-braided nylon
rope.
Some
synthetic
fiber
ropes
stretch
100
much.
Make a bridle for
each
craft (towing
and
towed)
by
putting
a
rope
completely
around
the
hull.
A WARNING
Always
stay
dear
of
any tight
or
slr<tched lines.
5-14
7870
Rogue
S."es
Downloaded from CruisersOwnersForum
http://www.CruisersOwnersForum.com