Repair manual
2-10
LAND
CRUISER (2F ENGINE) - Maintenance Operations
BRAKES
15. INSPECT
BRAKE
LINE
PIPES
AND
HOSES
NOTE: Inspect in a well lighted area, Inspect
the
entire
circumference
and
length
of
the brake
hoses
using a
mirror
as
required.
Turn
the
front
wheels
fully
right
or
left
before
inspecting
the
front
brake.
(a)
Check all brake lines and hoses
for:
• Damage
• Corrosion
• Wear
• Leaks
•
Deformation
• Bends
• Cracks •
Twists
(b) Check all clamps
for
tightness and connections
for
leakage.
(c)
Check
that
the
hoses and lines are clear
of
sharp edges,
moving parts and
the
exhaust
system.
(d) Check
that
the
lines installed
in
grommets
pass
through
the
center
of
the
grommets.
16. INSPECT REAR
BRAKE
LININGS
AND
DRUMS
(a)
Check
the
linings
for
wear.
Minimum
lining
thickness: 1.5
mm
(O.059 in.)
(b) Check
the
brake
drums
for scoring
or
wear.
Maximum
drum
inside
diameter:
297
mm
(11.69
in.)
(c)
Clean
the
brake
parts
with
a
damp
cloth
.
NOTE:
Do
not
use compressed air
to
clean
the
brake
parts.
17. INSPECT FRONT
BRAKE
PADS
AND
DISCS
(a) Check
the
th
ickness
of
the
disc brake pads and check
for
irregular wear.
Minimum pad thickness:
1.0
mm
(0.039
in.)
(b)
Check
the
disc
for
wear
or
runout.
Minimum
disc thickness:
19.0
mm
(0.748
in
.)
Maximum disc
runout
:
0.15
mm
(0.0059
in.)
'--
___________
-""=~='"
CHASSIS
lB.
REPACK FRONT WHEEL BEARINGS
(a)
Change
the
front
wheel bearing grease.
• Remove
the
hubs
and inner and
outer
bearings.
Clean in sol
vent
and inspect
the
bearings for
damage.
• Pack
the
bearings and axle
hubs
with
lithium base
multipurpose
grease.
Grease grade: Lithium base
multipurpose
grease
INLGI
No.
21
...
-
-