Repair manual

3- 12
LANO CRUISER (3B ,2 H ENGINE) - Maintenance Operations
24. INSPECT FRONT BRAKE PADS AND DISCS
(a) Check the thickness of the disc brake pads and check
for irregular wear.
Minimum pad thickness: 1.0 mm (0.039 in.)
(b) Check the disc for wear or runout.
Minimum di sc thickness: 19 .0 mm (0. 748 in.)
Maximum disc runout: 0.15 mm (0. 0059 in .)
CHASSIS
25. REPACK FRONT WHEEL BEARINGS
(a) Change the front wheel bearing grease.
• Remove the hubs and inner and outer bearings.
Clean in solvent and insp ect the bearings for
damage.
• Pack the bearings and axle hubs with li t hium base
multipurpose grease.
_ ____ _____ ___ -'""~""'""'1 Grease grade: Lithium base multipurpose grease
( NLGI No. 2)
(b ) Install the hubs and adjust the wheel bearing preload.
• Using SST, tighten the ad ju st nut and turn the hub
right and left two or three times.
SST 09607-60020
Torque: 600 kg-cm (43 ft -Ib, 59 N·m)
• Loosen the adjusting nut until it can be turned by
hand.
• Retighten the adjusting nut.
Torque: 40 - 70 kg·cm (35 - 60 in.-Ib, 4.0 - 6.8 N.m)
• Insure that the h ub turns smoothly and there is no
play in the bearing.