Specifications

20
OPERATION
OPERATION
OPERATION
OPERATION
Power
Power
Power
Power
on
on
on
on
and
and
and
and
Self-Test
Self-Test
Self-Test
Self-Test
To turn the detector on, connect power and turn the On/Off volume control
away from you until it clicks.
When powered up, the detector sounds a distinctive tone for each signal and
flashes in sequence as a self-test. Then all display turn off except the ‘ P ’ .
Memory
Memory
Memory
Memory
confirmation
confirmation
confirmation
confirmation
All features selected are retained in the memory. , which are H ighway/ C ity,
Brightness, Tone Sound, and VG-2.
Adjusting
Adjusting
Adjusting
Adjusting
Volume
Volume
Volume
Volume
To change the detector's volume, turn volume control either away or toward you .
Dim
Dim
Dim
Dim
Mode
Mode
Mode
Mode
Dim Mode reduces the illumination of the display. When pressing the button ,
the illumination reduces up to 50 %. When pressing the button for the second
time – all illumination is reduced except the ‘ P ’ . Pressing and holding the power
button a third time restores full illumination to the display.
Tutorial
Tutorial
Tutorial
Tutorial
Mode
Mode
Mode
Mode
Pressing CITY button for three seconds, the detector will demonstrate how it
operates when each radar and laser band signal is detected. To exit Tutorial
Mode, press any button after completing demonstration.
OPERATION
OPERATION
OPERATION
OPERATION
SETTINGS
SETTINGS
SETTINGS
SETTINGS
City
City
City
City
Operation
Operation
Operation
Operation
In modern cities there are many weak signals which have no relation to the
traffic signal controllers. The City mode reduces the detector's sensitivity to
weak signals and eliminates responses to false sources.
It ’ s important to notice that old or poorly shielded detectors in other vehicles can
sometimes transmit weak radar signals. So don ’ t forget to switch on the City
mode where it is necessary.
To select the C ity mode, press CITY button.
Press CITY button again to go back Highway mode