Owner`s manual

TROUBLE SHOOTING

Malfunction: no function

Reason: Remedy:

1. The power supply connection of the device is not correct. Recheck

2. The cabels have no mechanical or electrical contact. Recheck

3. The remote turn-on connection from the headunit to the amplifier is not correct. Recheck

4. Defective Fuses. In case of replacing the fuses, attend by any means the correct fuse rating. Replace Fuses

Malfunction: no signal on loudspeakers, but STATUS LED lights up green

Reason: Remedy:

1. The connection of the speakers or the RCA audio cables is not correct. Recheck

2. The speaker cables or the RCA audio cables are defective. Replace cables

3. Subsonic Controller is adjusted too high or Low Pass Controller is adjusted too low. Turn controller down or up

4. No signal from headunit. Check headunit settings

Malfunction: distortions

Reason: Remedy:

1. The loudspeakers are overloaded. Turn down the level

Turn down the level on the headunit

Switch off loudness on the headunit

Reset bass EQ on headunit or amp

Malfunction: No bass

Reason: Remedy:

1. The RCA audio cables are loose or defective. Reconnect or replacing the cables

Malfunction: amplifier runs into protection mode (STATUS LED lights up red)

Reason: Remedy:

1. Short circuit on the loudspeakers or cables. Reconnect

2. Insufficient air circulation by a inappropriate mounting position of the amplifier. Change the mounting position

Ensure air circulation

3. Overloaded by insufficient power supply (too thin profile section on the power cables). Use a bigger profile section

Malfunction: hiss or white noise on the loudspeaker’s signal

Reason: Remedy:

1. The level controllers are turned up. Turn down the level

2. The speaker cables or the RCA audio cables are defective. Replacing the cables

3. The hissing is caused by the headunit. Check the headunit