Operating instructions

!
Step 3.
The hot water unit is connected to a 240 volt power (on/off) wall
switch located inside a cupboard near the unit. Ensure that this is
plugged in and switched on.
See below:
! ! !
!
If either one of these three switches is in the ‘OFF’ position then the
hot water unit will not operate under 240 volt power.
---------------------------------------------------------------------------------------
-----------
!
!
!
!
!
!
Gas Operation:
!
For gas operation, please ensure the gas bottles are full and the gas
line is open. Also ensure that the gas cock valve is open to allow gas
to flow to the unit. By turning the ‘Water Heater’ button (picture
‘C’) on the ‘reset’ red light will alight and automatically operate the
unit.
! 6