Service manual

Intake Manifold Assemble
SIE-ID = 194513
1. Install the fuel meter body (5) into the lower intake
manifold (6).
2. Install the 8 poppet nozzles into the lower intake
manifold (6).
3. Inspect the poppet nozzles in order to ensure that
the poppet nozzles are firmly seated and locked
in the lower intake manifold bores.
4. Install the NEW fuel meter body seal (4) into the
groove on the fuel meter body (5).
5. Install the NEW upper intake manifold to lower
intake manifold gasket (3) into the groove of the
upper intake manifold (2).
6. Install the upper intake manifold (2) onto the lower
intake manifold (6).
7. If reusing the fasteners, apply threadlock
GM P/N United States 12345382,
GM P/N Canada 10953489, or equivalent, to the
threads of the upper intake manifold attaching
studs (1).
Notice: Refer to Fastener Notice in Cautions and
Notices.
8. Install the upper intake manifold studs (1).
Tighten
8.1. Tighten the upper intake manifold studs on
the first pass to 5 N·m (44 lb in).
8.2. Tighten the upper intake manifold studs on
the second pass to 10 N·m (89 lb in).
9. If reusing the fasteners, apply threadlock
GM P/N United States 12345382,
GM P/N Canada 10953489, or equivalent, to the
threads of the evaporative emission (EVAP)
canister purge solenoid valve studs.
10. Install the EVAP canister purge solenoid valve
and studs.
Tighten
Tighten the EVAP canister purge solenoid valve
studs to 10 N·m (89 lb in).
11. Install the engine wiring harness bracket and nut.
Tighten
Tighten the engine wiring harness bracket nut to
12 N·m (106 lb in).
500681
500680
6-96 Engine Mechanical - 5.0L and 5.7L Engine
2002 - Unit Repair (May 25, 2001)