Service manual

35. Install the accelerator control bracket, the bolt,
and the nut.
Tighten
Tighten the accelerator control bracket bolt and
the nut to 12 N·m (106 lb in).
Exhaust Manifold Cleaning and Inspection
SIE-ID = 784240
Caution: Refer to Safety Glasses Caution in
Cautions and Notices.
1. Clean the exhaust manifolds in cleaning solvent.
2. Dry the components with compressed air.
3. Inspect the exhaust manifolds for the following:
• Damage to the gasket sealing surfaces (1)
• Damage to the exhaust gas recirculation (EGR)
pipe fitting (2) (left manifold)
• Damage to the take down bolt hole threads (3)
• Broken or damaged exhaust manifold heat
shields (4), if applicable
• Restrictions within exhaust passages
• Damaged or cracked exhaust manifold
4. Measure the alignment or surface flatness of the
exhaust manifold flanges, using a straight edge
and a feeler gauge. Refer to
Engine Mechanical
Specifications (5.0 L)
or Engine Mechanical
Specifications (5.7 L)
.
If the surface flatness is not within specifications,
the exhaust manifold is warped and must be
replaced.
500661
521830
66607
6-100 Engine Mechanical - 5.0L and 5.7L Engine
2002 - Unit Repair (May 25, 2001)