Service manual

Engine Front Cover Installation
SIE-ID = 194773
Notice: Refer to Fastener Notice in Cautions and
Notices.
Important: Do not reuse the composite type engine
front cover and seal. Always install a NEW engine
cover, which includes a new seal.
1. Install the NEW engine front cover and bolts.
Tighten
Tighten the engine front cover bolts to
12 N·m (106 lb in).
Important: DO NOT reuse the original crankshaft
position sensor seal, O-ring. When installing the
crankshaft position sensor be sure the crankshaft
position sensor is fully seated and held stationary in
the engine front cover crankshaft position sensor bore.
A crankshaft position sensor that is not completely
seated will cock in the engine front cover and
may result in erratic engine operation.
2. Lubricate the NEW crankshaft position sensor
seal, O-ring, with clean engine oil.
3. Install the NEW crankshaft position sensor seal,
O-ring, onto the crankshaft position sensor.
4. Install the crankshaft position sensor.
5. Install the crankshaft position sensor bolt.
Tighten
Tighten the crankshaft position sensor bolt to
9 N·m (80 lb in).
69010
387759
11485
Engine Engine Mechanical - 5.0L and 5.7L 6-117
2002 - Unit Repair (May 25, 2001)