Service manual

Oil Pump, Pump Screen and Deflector
Installation
SIE-ID = 194869
Tools Required
J 36660-A Torque Angle Meter
1. Inspect for properly installed oil pump locator pins.
Important: Do not reuse the oil pump driveshaft
retainer (4).
During assembly, install a NEW oil pump driveshaft
retainer.
2. Assemble the oil pump (3), the oil pump
driveshaft (5), and a NEW oil pump driveshaft
retainer (4).
3. Install the oil pump (3).
Position the oil pump onto the pins.
Notice: Refer to Fastener Notice in Cautions and
Notices.
4. Install the crankshaft oil deflector (2) and the
nuts (6).
5. Install the bolt (1) attaching the oil pump to the
rear crankshaft bearing cap.
Tighten
• Tighten the oil pump bolt on the first pass to
20 N·m (15 lb ft).
• Tighten the oil pump bolt on the final pass to
65 degrees using the
J 36660-A .
• Tighten the crankshaft oil deflector nuts to
40 N·m (30 lb ft).
182852
11438
6-118 Engine Mechanical - 5.0L and 5.7L Engine
2002 - Unit Repair (May 25, 2001)