Service manual

Oil Filter Adapter Installation
SIE-ID = 69508
1. Apply clean engine oil GM P/N United
States 12345610, GM P/N Canada 993193, or
equivalent, to the NEW oil filter adapter seal,
O-ring, if applicable.
2. Install the NEW oil filter adapter seal into the
groove in the oil filter adapter, if applicable.
3. Install the NEW oil filter adapter gasket, if
applicable, and the oil filter adapter.
Notice: Refer to Fastener Notice in Cautions and
Notices.
4. Install the oil filter adapter flat washers, if
applicable, and the oil filter adapter bolts.
Tighten
Tighten the oil filter adapter bolts to
25 N·m (18 lb ft).
Crankshaft Balancer Installation
SIE-ID = 66868
Tools Required
J 23523-F Balancer Remover and Installer
1. Ensure that the crankshaft balancer front groove
pin is the proper length and installed in the proper
location, if applicable.
Notice: SIO-ID = 16580 The inertial weight section of
the crankshaft balancer is assembled to the hub with
a rubber type material. The correct installation
procedures (with the proper tool) must be followed or
movement of the inertial weight section of the hub
will destroy the tuning of the crankshaft balancer.
2. Apply a small amount of adhesive GM P/N United
States 12346141, GM P/N Canada 10953433, or
equivalent, onto the crankshaft balancer
keyway in order to seal the crankshaft balancer
keyway and crankshaft joint.
3. Install the crankshaft balancer onto the end of the
crankshaft.
Align the keyway of the crankshaft balancer with
the crankshaft balancer woodruff key.
4. Install the crankshaft balancer onto the end of the
crankshaft.
39122
182849
182832
Engine Engine Mechanical - 5.0L and 5.7L 6-121
2002 - Unit Repair (May 25, 2001)