Service manual

Cylinder Head Installation - Left
SIE-ID = 650067
Tools Required
J 36660-A Torque Angle Meter
1. Clean the cylinder gasket surfaces on the
engine block.
2. Inspect the cylinder head locator dowel pins for
proper installation.
3. Clean the cylinder head gasket surfaces on the
cylinder head.
Important: Do not use any type sealer on the cylinder
head gasket, unless specified.
4. Place the NEW cylinder head gasket in position
over the cylinder head locator dowel pins.
The cylinder head gasket is not directional and
may be installed using either side facing the
engine block.
5. Install the cylinder head to the engine block.
Guide the cylinder head carefully into place over
the dowel pins and the cylinder head gasket.
182846
317233
317227
6-124 Engine Mechanical - 5.0L and 5.7L Engine
2002 - Unit Repair (May 25, 2001)