Service manual

Notice: SIO-ID = 382467 Proper lower intake manifold
fastener tightening sequence and torque is critical.
Always follow the tightening sequence, and torque the
intake manifold bolts using the 3 step method.
Failing to do so may distort the crankshaft bearing
bore alignment and cause damage to the crankshaft
bearings.
9. Install the lower intake manifold bolts.
Tighten
9.1. Tighten the bolts on the first pass in
sequence (1–8) to 3 N·m (27 lb in).
9.2. Tighten the bolts on the second pass in
sequence (1–8) to 12 N·m (106 lb in).
9.3. Tighten the bolts on the final pass in
sequence (1–8) to 15 N·m (11 lb ft).
10. Connect the evaporative emission (EVAP) canister
purge solenoid valve harness.
10.1. Push the elbow inward until the quick
connect snaps into place.
10.2. Pull the elbow outward in order to ensure
proper connection.
Distributor Installation
SIE-ID = 69509
1. Bring cylinder number one piston to Top Dead
Center (TDC) of compression stroke.
500689
317211
195336
6-132 Engine Mechanical - 5.0L and 5.7L Engine
2002 - Unit Repair (May 25, 2001)