Service manual

Valve Rocker Arm Cover
Installation - Right
SIE-ID = 650070
Important: Always install a NEW valve rocker arm
cover gasket.
1. Install the NEW valve rocker arm cover gasket.
2. Install the valve rocker arm cover.
Notice: Refer to Fastener Notice in Cautions and
Notices.
3. Install the valve rocker arm cover washers
and bolts.
Tighten
Tighten the bolts to 12 N·m (106 lb in).
Water Pump Installation
SIE-ID = 69040
Tools Required
J 41240 Fan Clutch Remover and Installer
1. Apply sealant GM P/N United States 12346004,
GM P/N Canada 10953480, or equivalent, to the
threads of the water pump bolts.
2. Install NEW water pump gaskets.
3. Install the water pump.
Notice: Refer to Fastener Notice in Cautions and
Notices.
4. Install the water pump bolts.
Tighten
Tighten the water pump bolts to 45 N·m (33 lb ft).
Important: After final assembly, the water pump inlet
hose clamp tangs, water pump end, must point
forward and the upper tang should be level with the
outside diameter of the water pump inlet hose.
5. Install the water pump inlet hose and the water
pump inlet hose clamps.
182833
69011
182853
6-136 Engine Mechanical - 5.0L and 5.7L Engine
2002 - Unit Repair (May 25, 2001)