Service manual

Engine Flywheel Installation
SIE-ID = 784241
1. Install the engine flywheel (1 or 2) to the
crankshaft.
Align the engine flywheel locator hole to the
flywheel locator pin.
Important: If replacing the engine flywheel (manual
transmission), note the position and length of the
original flywheel weights, if applicable. Flywheel
weights of the same length must be installed into the
new engine flywheel in the same location as the
flywheel weights were in the old engine flywheel.
2. Note the position of the flywheel weights
and install the NEW flywheel weights as required.
A properly installed flywheel weight will be
flush or slightly below flush with the face of the
engine flywheel.
Notice: Refer to Fastener Notice in Cautions and
Notices.
3. Install the engine flywheel bolts.
Tighten
Tighten the engine flywheel bolts in sequence (1–
6) to 100 N·m (74 lb ft).
188129
64126
63174
Engine Engine Mechanical - 5.0L and 5.7L 6-139
2002 - Unit Repair (May 25, 2001)