Service manual

25. Rotate the fine adjustment knobs, on the dial
indicator end of the swivel base, to position the tip
of the indicator in contact with the connecting rod.
26. Lightly actuate the handle of the pivot arm
assembly, multiple times in both directions, to
ensure the oil film is removed from the journal.
27. Load the handle in the forward position and
zero the dial indicator. Load the handle multiple
times in both directions and record the reading.
Important: During this procedure, card stock may
enter the crankshaft journal oil galleries. Remove all
card stock from the bearing journal and oil galleries
prior to reassembly.
28. Remove the bearing cap bolts, cap, and
paper stock.
29. Replace bearing halves, as required, to obtain the
proper bearing clearances.
30. Install the bearings, cap, and bolts. Refer to
Fastener Tightening Specifications .
627132
627141
627135
6-62 Engine Mechanical - 5.0L and 5.7L Engine
2002 - Unit Repair (May 25, 2001)