Service manual
3.14. Tighten the
J 33049
expander assembly nut
until snug.
3.15. Push the
J 33049
guide cone into the
camshaft front bearing in order to align
the
J 33049
.
3.16. Drive the camshaft inner bearing #4 from
the camshaft inner bearing bore #4.
3.17. Loosen the
J 33049
expander assembly nut.
3.18. Remove the camshaft inner bearing #4
from the
J 33049
expander assembly.
4. Remove the
J 33049
from the engine block.
5. Remove the camshaft outer bearings #1 and #5.
5.1. Insert the
J 33049
into the camshaft outer
bearing #1.
5.2. Tighten the
J 33049
expander assembly nut
until snug.
5.3. Drive the camshaft outer bearing #1 from
the camshaft outer bearing bore #1.
5.4. Loosen the
J 33049
expander assembly nut.
5.5. Remove the camshaft outer bearing #1
from the
J 33049
expander assembly.
5.6. Remove the
J 33049
from the engine block.
5.7. Insert the
J 33049
into the camshaft
outer bearing #5.
5.8. Tighten the
J 33049
expander assembly nut
until snug.
5.9. Drive the camshaft outer bearing #5 from
the camshaft outer bearing bore #5.
5.10. Loosen the
J 33049
expander assembly nut.
5.11. Remove the camshaft outer bearing #5
from the
J 33049
expander assembly.
6. Remove the
J 33049
from the engine block.
7. Discard the camshaft bearings.
Camshaft Bearing Installation
SIE-ID = 195136
Tools Required
J 33049
Camshaft Bearing Service Kit
Important: Always install the camshaft outer bearings
#1 and #5 first. The camshaft outer bearings serve
as a guide for the
J 33049
and help center the
camshaft inner bearings during the installation process.
Look to ensure that the camshaft bearing lubrication
hole or holes align with the oil gallery hole or holes in
the engine block. On some engines, the oil gallery
holes may be difficult to see. Verify that the camshaft
bearing lubrication holes and the oil gallery holes
are aligned.
1. Assemble the
J 33049
handle (10), the expanding
driver (4–8), the washer (2 or 3), and the expander
assembly (15).
63219
66100
6-70 Engine Mechanical - 5.0L and 5.7L Engine
2002 - Unit Repair (May 25, 2001)