Owner's Manual

1. Carefully remove the radio to gain access to the radio connectors.
2. Locate the 12-pin CD changer port in the Quadlock connector. If there is a connector plugged into
this cavity, you need to unplug it.
3. Plug the WHITE/BLACK 12-pin connector of the BTS-VW2 to the CD changer port of the radio.
4. Connect the BLACK wire with a ring terminal to a solid chassis ground.
5. If the line-in feature will be used, plug a 3.5mm to 3.5mm cable (sold separately) to the BTS-VW2
module and run towards the desired location.
6. If a USB flash drive will be used, plug in a male to female USB cable (not included) to the
BTS-VW2 module and run to the desired location.
7. You can also mount the BTS-VW2 to an accessible location such as the center console or glove
box, to use the 3.5mm line-in and USB features.
8. Test the system for functionality before putting back the radio.
For Bluetooth function:
1. Turn on the radio and press the CD button. Screen will show “CD1 TR1”.
2. Go to the Bluetooth menu on your phone and connect to “Crux BT”.
3. BTS-VW2 will announce when the phone has been connected.
4. Play the music on your phone or other audio player and audio should be heard on the factory
sound system.
For USB Mode:
1. Plug in your USB flash drive to the BTS-VW2 USB port.
2. Turn on the radio and press the CD button. Screen will show “CD1 TR1”.
3. BTS-VW2 will announce “USB Mode”.
4. USB Audio should be heard on the factory sound system. Use the radio knobs or steering wheel
controls to track up and track down.
For Line-In Mode:
1. Plug in a 3.5mm to 3.5mm cable (sold separately) to the BTS-VW2 USB line-in jack.
2. Turn on the radio and press the CD button. Screen will show “CD1 TR1”.
3. BTS-VW2 will announce “Line-In Mode”.
4. Plug the other end of the 3.5MM cable to the audio player and press play. Audio should be heard
on the factory sound system
.
Magnetic Phone Mount Assembly and Use:
1. Pop-in magnetic head to base socket.
2. Tighten locking nut to desired tilt.
3. Slide into the AC vent grille.
4. Use the desired metal plate size and stick
on the back of the phone or insert behind
the phone case.
Rev.060116
2/2