Owner's Manual

RVCTY-71T
Rear View Integration with Camera for
Toyota Tacoma Truck 2014-2015
R
INTERFACING SOLUTIONS
Sightline
Multi View Integration
Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311
phone: [phone] • fax: [phone] • www.cruxinterfacing.com
rev.053019
1 of 1
- Automacally switches to rear-view when vehicle is in reverse gear.
- Adjustable angle rear-view camera included.
- Plug & Play Installaon.
PRODUCT FEATURES:
(Cut to ip image Horizontally)
(Cut to remove parking lines)
Rotate Camera
to ip image Vertically
BLUE wire
WHITE wire
4-Pin
(Male plug to factory pre-wire)
INSTALLATION DIAGRAM:
Installing the Camera
1. Remove the tailgate cover.
2. On the right side of the tailgate handle, drill a 5/8” hole using the hole saw included.
3. Route the camera power and video connecons through 5/8” hole. Do not secure the camera to the handle yet
unl aer tesng the angle.
4. Connect the 4-Pin plug of the Camera Harness to the factory connector underneath the truck, near the spare re.
5. Disconnect the negave baery terminal for a few seconds
and reconnect to reset the factory system and recognize the
new camera.
6. Test the camera by pung the vehicle in reverse gear.
7. Check the camera viewing angle then secure it to the handle.
8. Re-install the tailgate cover.
Factory 4-Pin connector
VEHICLE APPLICATIONS:
2014 - 2015 Toyota Tacoma