Owner's Manual

Crux Interfacing Solutions • Chatsworth, CA 91311
phone: [phone] • fax: [phone] • www.cruxinterfacing.com
rev.040121
SWRFD-60L
Radio Replacement with SWC + Aux Input Retention
for FORD, LINCOLN & MERCURY Vehicles
1 of 3
RADIO REPLACEMENT
SWC RETENTION
+
R
INTERFACING SOLUTIONS
- Retains factory features in select FORD, LINCOLN, and MERCURY vehicles while funconing with an aermarket
radio.
- Pre-programmed to retain factory Steering Wheel Controls (on vehicles without Sync).
- iPhone Voice Recognion (VR) feature from SWC on select Kenwood, Pioneer, Alpine and JVC radios.
- Retains factory Aux-Input and Subwoofer (if equipped).
- EIA color coded wiring for easy installaon.
PRODUCT FEATURES:
PARTS INCLUDED:
INSTALLATION DIAGRAM:
SWRFD-60L MODULE SWRFD-60L HARNESS Antenna Adapter SWC CABLE
AFTERMARKET
RADIO
+12V Constant Yellow
+12V ACC Red
12V Ground Black
Illumination Orange
Power Antenna Blue
Vehicle Speed Sense Pink
Antenna Turn-on Blue
Right Front (+) Gray
Right Front (-) Gray/Black
Left Front (+) White
Left Front (-) White/Black
Right Rear (+) Violet
Right Rear (-) Violet/Black
Left Rear (+) Green
Left Rear (-) Green/Black
Subwoofer Amp Turn-on Blue/White
Subwoofer
Factory Aux Input
24-Pin
Plug*
16-Pin
Plug*
8-Pin
Plug*
TO FACTORY
HARNESS
12-Pin
Connector
SWC TYPE
(Connect PINK to PINK wire)
Subwoofer
Converter
Module
*Inspect that the male pins are
properly lined up before plugging
into the factory harness.
SWRFD-60L
MODULE
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
AFTERMARKET
RADIO SELECTOR
(See Chart)
FORD
SWC SETTING
(OFF OFF OFF OFF)
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
Cap or insulate if
not being used
Kenwood/JVC (BLUE / YELLOW)
Insulate with tape
if not being used
3.5MM SWC CABLE
Plug in the 3.5MM SWC cable to the 4-pin port
on the module. See “DIP SWITCH SETTINGS” section.
Blue/Yellow
(Not Used)