Owner's Manual

Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311
phone: [phone] • fax: [phone] • www.cruxinterfacing.com
rev.020720
2 of 2
RADIO REPLACEMENT
SWC RETENTION
+
R
INTERFACING SOLUTIONS
VEHICLE APPLICATIONS:
Hyundai
2011 – 2016
2013 – 2016
2013 – 2016
2013 – 2016
2011 – 2016
2011 – 2015
2010 – 2015
2012 – 2013
Elantra
Genesis Coupe*
Santa Fe*
Santa Fe Sport*
Sonata*
Sonata Hybrid*
Tucson
Veloster
Kia
Late 2011 – 2013
2014 – 2015
2012 – 2013
2014 – 2016
2012 – 2013
Late 2011 – 2014
2011 – 2016
Optima
Optima*
Sorento (with UVO)*
Sorento*
Soul*
Rio
Sportage
SWRHK-65E
Radio Replacement with Steering Wheel Retention for
HYUNDAI and KIA Vehicles with 24 & 18 Pin Connectors
DIP SWITCH SETTINGS:
HYUNDAI / KIA STEERING WHEEL CONTROL DIP SWITCH SETTING:
AFTERMARKET RADIO DIP SWITCH SETTINGS:
NOTES:
*For vehicles without NAV.
Not compable with amplied systems.
DIP: 5 6 7 8
Hyundai
OFF OFF ON ON
SWC MODULE
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
RADIO BRAND: DIP: 1 2 3 4
Atoto, Dual, Farenheit, Jensen, Pioneer
Power Acoustik, Soundstream
Blaupunkt, Most o-brand Radios
Alpine
Clarion
Kenwood
JVC
Boss, Old Sony
New Sony
OFF OFF ON ON
OFF OFF ON ON
OFF OFF ON ON
OFF OFF OFF OFF
OFF ON ON OFF
OFF ON ON ON
OFF ON OFF ON
OFF ON OFF OFF
OFF OFF ON OFF
SWC MODULE
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
NOTE: For Atoto, Blaupunkt, Dual, Farenheit, Power Acoustik, Soundstream, and most o-brand radios,
check the aftermarket radio’s manual to see if the SWC buttons need to be programmed.
3.5MM SWC CABLE
Plug in the 3.5MM to 4-Pin SWC cable and set the DIP switches to the aermarket radio you are using. Use the
Blue/Yellow wire for Kenwood and JVC radios and the 3.5mm plug for other radios.
NOTE: Insulate the Blue/Yellow wire or 3.5mm plug if not being used.
RED to SWC Key 1
WHITE to SWC Key 2
SHIELD to SWC Ground
For aermarket radios that have wires for SWC connecons, cut o the 3.5mm plug on the Crux SWC Cable and connect the
SWC wires as follows:
Note that there are some radios that only have
SWC1 and SWC2, in this case “shield” does not
need to be connected.