Manual

Crux Interfacing Solutions • 6860 Canby Ave., Suite 104, Reseda, CA 91335
phone: [phone] • fax: [phone] • www.cruxinterfacing.com
rev122018
2 of 5
INSTALLATION DIAGRAM:
INSTALLATION INSTRUCTIONS:
THE AV INTERFACE:
1. Remove the factory radio from the dashboard.
2. Unplug the factory 54 pin connector from behind the factory display.
3. Mate the WVIFD-02F T-Harness connecons to the factory connectors. (Make sure all connectors are
properly seated into the interface and into the radio.
4. Plug the C-500 and C-125 modules to the 8-pin Molex connectors on the WVIFD-02F harness.
NOTE: The 2 modules are interchangeable.
5. Set the DIP switches on both modules. See next page.
54-PIN
(female plug)
TO FACTORY
DISPLAY
----------------- -
----------------- -
----------------- -
54-PIN
(male plug)
8-PIN
(male plug)
WHITE /12V OUTPUT
4 5 6
ON
1 2 3
4 5 6
ON
1 2 3
C-500
Module
C-125
Module
SONY
8” RADIO
WHITE / 12V OUTPUT
BLACK WIRE OF
8-PIN CONNECTOR
STATUS LED’S
STATUS LED’S
8-PIN
(male plug)
BLACK WIRE/ TAP HERE
TOGGLE SWITCH*
ENABLEDISABLE
GREEN / VIM
GREEN / VIM
RED WIRE/ TAP HERE
TO FACTORY
HARNESS
TO FACTORY
AV INPUT
FOR DIP SWITCH SETTINGS
SEE PAGE 3
FOR DETAILS
IMPORTANT NOTE:
Before connecting the interface to the
harness, If the vehicle is equipped w/ Factory
RVC make sure Dip 2 = ON
Failure to do so will result in loss of the
RED WIRE (12V ACC)
(POWER the Wi-Fi module)
Wi-Fi
INTERFACE
HDMI OUTPUT
MODE BUTTON
(5G or 2.4G)
VIDEO INPUT
BLACK GROUND
RED +12V
PURPLE VIDEO INPUT TRIGGER +12V
ANTENNAS
USB INPUT / CHARGER
factory rear-view camera.
*See note below.
WVIFD-02F
Wi Connectivity Integration and Audio Video Interface
for Select FORD F-Series Trucks with MyFord Touch Radios
R
INTERFACING SOLUTIONS
A/V
SERIES
NOTES:
1. The radio will go through a reboot process that can take up to 1 minute. It will inialize and re-load all
previous sengs. Once complete it will resume the original radio display.
2. There is no SWC acvaon available for these Ford trucks. You will need to use a toggle switch and connect
the GREEN wires of both modules to +12V power to use the VIM funcon.