Owner’s Manual

WVIGM-04
Wi Connectivity Integration for
Select GM LAN 29 Bit Vehicles 2006-2015
R
INTERFACING SOLUTIONS
A/V
SERIES
Crux Interfacing Solutions • Chatsworth, CA 91311
phone: [phone] • fax: [phone] • www.cruxinterfacing.com
rev.1103204 of 8
3) Connect the 8 pin Molex connector on the WVIGM-04 t-harness to the main interface module.
NON-PERMANENT VIDEO IN MOTION OPTION:
4) Aer connecng the harness, the interface module only requires DIP #1 to be set to ON. All other DIP
switches should be set to OFF unless the VIM feature causes a delay in the GPS posion updang. If this
happens, please see below to use the non-permanent VIM opon.
4 5 6
ON
1 2 3
DIP 1 = ON
2
3
4
5
DIP 6
OFF
ACTIVATE
VIDEO
IN-MOTION
If you have set DIP# 1 to the ON posion, then the Video In Moon funcon is permanently ON. If this causes
a delay in the GPS funcon, use the non-permanent VIM opon instead.
1) Set DIP# 1 to OFF.
2) Use the side mirror controls to acvate and deacvate the VIM funcon.
3) The side selector switch must be in the center posion and the indicator lights must be OFF.
ENABLE
(Video In-Motion)
DISABLE
(Video In-Motion)
LEFT RIGHT
CENTER POSITION
The side mirror controller
is located on the driver side
door panel.
Side mirror control must be set in the center position
to use this function. Indicator lights must be OFF.