Manual

CONNECTING THE INTERFACE TO POWER AND GROUND
Follow these steps to properly install the interface module.
Step 5 -The power for the module can be found on the GREEN 16-PIN connector. Located next to the GRAY connector.
RED = 12V CONSTANT / BLACK = GROUND (Make sure to measure the wires with a volt meter rm)
Step 6 - Connect the 24-Pin AV Input/Output Cable to the Main Interface module. Connect the Camera and other Devices to the inputs
on this cable. See labels on the cables for descriptions. The AV outputs can be used to go to an external monitor.
Wi-Fi Connectivity and Audio/Video Interface for
Select CADILLAC, CHEVROLET & GM Vehicles with Cue or MyLink Radios
WVIGM-04M
Crux Interfacing Solutions
www.cruxinterfacing.com
tel. #: [phone]
fax #: [phone]
Step 7 - After connecting the module, set the proper dip switches to the “ON” position.
The interface requires DIP Switch 1 to be “ON”. Unless you are using the toggle switch option.
5 / 8 rev.082516