Manual

7
Wi-Fi Connectivity and Audio/Video Interface for
Select CADILLAC, CHEVROLET & GM Vehicles with Cue or MyLink Radios
WVIGM-04M
Crux Interfacing Solutions
www.cruxinterfacing.com
tel. #: [phone]
fax #: [phone]
1. Screw on the antenna to the interface.
2.
Connect the BLUE wire to +12V to trigger the AV input feature. The AV INPUT can be connected to
an AV source with composite output. A toggle switch (not included), wired between the BLUE wire
and +1
2V can be used to switch ON or OFF the AV INPUT feature. The AV INPUT can also be used
for a rear-view camera op
on. Connect the BLUE wire to the reverse light +12V lead to toggle this
feature.
3. The WVIGM-04 also offers 2 RCA video outputs for mul
ple monitor set-ups.
4. An HDMI video output is available for HD video resolu
on. HDMI cable is not included in the kit.
5. Switch to the new AV input
by using the SWC or the radio.
6. Test the interface and re-install the radio into the dash.
With the Interface ON and READY:
On the iOS 7 and up:
Swipe your finger from the bo
om up on the iPhone or iPad. From the Quick Menu, turn ON the
Wi-Fi and connect to “HotSpot”.
A
er connec ng the Wi-Fi from that same screen, select AirPlay to connect to the interface.
For the Android system:
T
ap the Menu bu
on at the top of your screen and select Enable wireless display. Your phone will
scan for nearby Miracast devices and display them in a list under Cast Screen.
MIRRORING:
SETTING YOUR DEVICE
The mirroring connection uses a direct WiFi connection to transfer
the Audio and Video from your device to the OE monitor. This does
not require an active network.
If your smartphone has the Screen Time Out enabled and your
display goes to sleep mode, you will no longer see the image
on the screen. Deactivate this feature for continuous viewing.
To Select the A/V source, press the
VIDEO button to see the new menu,
then select REAR MEDIA.
7 / 8 rev.082516