Manual

CONNECTING THE INTERFACE
Follow these steps to properly install the interface module.
Step 1 - Remove the factory radio to gain access to the factory 14 and 16-Pin connectors.
Make sure to remove the proper 14 and 16-Pin connectors. (See below)
Black to Black and Brown to Brown (Use the two end connectors).
Step 2 - The attached GPS antenna is to be used if the interface is having problems with the Video In-Motion feature while the vehicle is moving.
Not every vehicle will need to have this GPS harness connected.
We recommend leaving the cable disconnected during the install. Test the VIM while driving and if no issues with the VIM staying active, leave the GPS
antenna alone. Only in the case where the VIM deactivates while the vehicle is in motion, then we recommend connecting the GPS antenna.
8-PIN
(male plug)
4 5 6
ON
1 2 3
TO F ACTOR Y
HARNESS
16-PIN
(male plug)
14-PIN
(male plug)
16-PIN
(male plug)
14-PIN
(male plug)
TO F ACTOR Y
RADIO
GPS
antenna
GPS
antenna
Wi-Fi Connectivity and Audio/Video Interface for
Select GM LAN 29 Bit Vehicles 2006 - 2015
WVIGM-04
Crux Interfacing Solutions
www.cruxinterfacing.com
tel. #: [phone]
fax #: [phone]
3 / 8 rev.082416