Manual

CONNECTING THE INTERFACE
Follow these steps to properly install the interface module.
Step 3 - Connect the 8-Pin connector on the provided T-Harness to the main interface module.
Make sure all your connections are mly inserted into the module.
Step 4 -
After connecting the module, the interface only require DIP switch 1 to be “ON”. All other DIP Switches should be “OFF” unless the
VIM features causes a delay in GPS position updating. If this happens, please refer to page 5 to use a Non-Permanent VIM feature.
DIP SWITCH DESCRIPTION
Up = ON, Down = OFF
DIP 1 = Video In-Motion (Always On)
DIP 2 = Not Used
DIP 3 = Not Used
DIP 4 = Not Used
DIP 5 = Not Used
DIP 6 = Not Used
After each change of the DIP switch settings,
we recommend powering down the module,
then restarting the module.
LED INDICATORS
BLUE LED:
Blinking = No BUS Detected.
Solid = BUS Recognized.
OFF = Power Down/ Sleep mode.
RED LED:
ON = Power On
OFF = Power OFF
8-PIN
(male plug)
4 5 6
ON
1 2 3
10-PIN
(male plug)
Wi-Fi
INTERF ACE
BLACK /
GROUND
RED / 12V AC C
FACTOR Y
A/V INPUT
TO F ACTOR Y
A/V INPUT
RED WIRE/ 12v ACC
(To POWER the Wi-Fi module)
TO F ACTOR Y
HARNESS
14-PIN
(male plug)
14-PIN
(male plug)
TO F ACTOR Y
RADIO
GPS
antenna
GPS
antenna
4 5 6
ON
1 2 3
DIP 1 = ON
2
3
4
5
DIP 6
OFF
ACTIVATE
VIDEO
IN-MOTION
BLACK WIRE/ GROUND
(To GROUND the Wi-Fi module)
Wi-Fi Connectivity and Audio/Video Interface for
Select GM LAN 29 Bit Vehicles 2006 - 2015
WVIGM-04
Crux Interfacing Solutions
www.cruxinterfacing.com
tel. #: [phone]
fax #: [phone]
4 / 8 rev.082416