Manual

NON-PERMANENT VIDEO IN-MOTION
If you have set Dip Switch number 1 to the “ON” position, then the Video In-Motion function is permanently ON.
There have been reports of the Video In-Motion causing delays in the GPS updating, results may vary.
Step 1 -If you choose to leave the Video In-Motion feature OFF due to the GPS updating, you can still access
this feature via the SIDE MIRROR control. (This is the non-permanent method)
Using the side mirror control you can activate and deactivate the VIM
while driving
High Tone = Activated
Low Tone = Deactivate
For Video In-Motion:
Press the UP arrow to enable the VIM.
Press the DOWN arrow to disable the VIM.
ENABLE
(Video In-Motion)
DISABLE
(Video In-Motion)
LEFT RIGHT
CENTER POSITION
Side mirror control must be set in the center in order
to use the functions. Indicator lights must be OFF.
THIS CONTROLLER IS LOCATED
ON THE LEFT HAND SIDE OF
THE DRIVERS SEAT.
Wi-Fi Connectivity and Audio/Video Interface for
Select GM LAN 29 Bit Vehicles 2006 - 2015
WVIGM-04
Crux Interfacing Solutions
www.cruxinterfacing.com
tel. #: [phone]
fax #: [phone]
5 / 8
rev.082416
Step 1
-
Connect both wires to the module and make sure you are getting the WiFi module to turn on. A RED LED will conrm that
8-PIN
(male plug)
4 5 6
ON
1 2 3
FACTORY
A/V INPUT
TO FACTORY
A/V INPUT
RED WIRE (12V ACC)
(To POWER the Wi-Fi module)
BLACK WIRE (Ground)
(To GROUND the Wi-Fi module)
Wi-Fi
INTERFACE
HDMI OUTPUT
RED = +12V ACC
BLACK = GROUND
BLUE = A/V TRIGGER*
A/V INPUT
VIDEO OUTPUTS
*Connect BLUE wire to +12V
to toggle A/V INPUT
A/V OUTPUT
A/V CABLE
The interface provides a RED wire for 12V ACC and a BLACK wire for GROUND to the WVI-X WiFI module.
CONNECTING THE WVI-X (WiFi Module)
the WiFi module is on.