Installation Manual

Cryptera A/S SV/INT3520-2000-10 rev.B Page 8 of 22
Installation Manual
3 Handling the Device
The NFC Reader is a PCI PTS approved device, which implies a number of internal
security features – triggering any of these will disrupt the normal operation of the device.
To avoid triggering these security features inadvertently, please read and follow the
instructions given below.
3.1 Tamper Detection
The NFC Reader is a tamper responsive device, which contains a number of internal
sensors. To avoid triggering these, please observe the following:
 Do not open or disassemble the device.
 Do not drop the device on a hard surface.
 Do not subject the device to strong vibrations.
 Do not expose the device to extreme temperatures (below ÷25 °C or above
+60 °C), neither in operation nor while transporting or storing.
 Do not remove the internal backup battery.
 Minimize the risk of ESD when handling the device.
3.2 ESD Precautions
During the installation and handling of the device, the operator must at all time use ESD
protective measures to prevent an ESD event.
It is recommended to mount the device and ensure proper grounding before connecting
the USB cable.
3.3 Cabling
The NFC reader requires a USB connection to the host system.
The device is USB bus powered, so an external power supply is not required.
To assure proper grounding of the device, please connect the GND-connector to the kiosk
cabinet using an adequate cable, and make sure that the USB host is also proper grounded
to the kiosk cabinet.
3.4 LED Indication
The NFC Reader has operational LED’s on the front-side, and diagnostic LED’s on the
back-side.
The operational LED’s – consisting of the white logo LED and four green LED’s –
indicate the operational state of the device and the transaction progress, which guides
cardholder when using the device.