Installation guide

12
Figure 3: Connection of speakers and subwoofer with receiver.
4 Speakers & subwoofer connections with your AV receiver
IMPORTANT: All connections must be made with the equipment switched off. Refer
to your AV receiver manual before proceeding with connections.
Connections to the speakers are made at the binding post terminals located on the rear
panel of the receiver. These terminals permit a variety of connection methods.
1. Single-wire: Ensure the positive binding post on the speaker (marked in red) is
connected to the positive output terminal of the amplifier or receiver. Similarly, the
negative speaker terminal (marked in black) is connected to the negative amplifier or
receiver output terminal. Incorrect connections can result in poor imaging and reduced
bass output.
2. Bi-wire (not supported on all speakers): Remove the jumper links by loosening
the speaker terminal caps and use a separate pair of speaker cables from the amplifier
or receiver to each pair of speaker binding posts. Bi-wiring can improve resolution of
low-level detail. Always observe correct polarity. Incorrect connections can also degrade
bass, focus and imaging.