Technical Specifications

ManualsBrandsCrystal Blue ManualsOutdoor DecorCrystal Plex® Algae Control - 1 Gallon

7 68980 00444 8

Distributed by:

Sanco Industries

P.O. Box 11617

Fort Wayne, IN 46859

KEEP OUT OF REACH OF CHILDREN

DANGER

Active Ingredient:

*Copper Sulfate Pentahydrate (CAS #7758-99-8)......19.8%

Other Ingredients..................................................................80.2%

Total.........................................................................................100.0%

*metallic copper equivalent 5.04%

See attached booklet for additional

Precautionary Statements

EPA Reg. No. 83190-1-72838

EPA Est. No. 072838-IN-003

FIRST AID

If in Eyes: Hold eye open and rinse slowly and gently with water for 15-20 minutes.

Remove contact lenses, if present, after the ﬁrst 5 minutes, then continue rinsing

eye. Call a poison control center or doctor for treatment advice. If on Skin or

Clothing: Take oﬀ contaminated clothing. Rinse skin immediately with plenty of

water for 15-20 minutes. Call a poison control center or doctor for treatment

advice. If Swallowed: Call a poison control center or doctor immediately for

treatment advice. Have person sip a glass of water if able to swallow. Do not

induce vomiting unless told to do so by a poison control center or doctor. Do not

give anything by mouth to an unconscious person.

Have the product container or label with you when calling a poison control center

or doctor or going for treatment. You may also contact 1-800-255-3924 for

emergency medical treatment information.

NOTE TO PHYSICIAN: Probable mucosal damage may contraindicate the use of

gastric lavage.

Treats Livestock Water Supplies

Water treated with this product may be used for swimming, ﬁshing and irrigation. For use in:

lakes; reservoirs destined for drinking water; swimming areas; canals, ditches, and laterals.

Algae Control

Crystal Plex

Net Contents: 1 Gallon (3.78 Liters)

090718

L4002

Summary of content (8 pages)

PAGE 1
Crystal Plex ® Algae Control Treats Livestock Water Supplies Water treated with this product may be used for swimming, fishing and irrigation. For use in: lakes; reservoirs destined for drinking water; swimming areas; canals, ditches, and laterals. R FIRST AID KEEP OUT OF REACH OF CHILDREN DANGER See attached booklet for additional Precautionary Statements Net Contents: 1 Gallon (3.78 Liters) EPA Reg. No. 83190-1-72838 EPA Est. No. 072838-IN-003 Distributed by: Sanco Industries P.O.
PAGE 2
See inside for additional Precautionary Statements and complete Directions for Use. DIRECTIONS FOR USE It is a violation of Federal Law to use this product in a manner inconsistent with its labeling. Do not apply this product in a way that will contact adults, children or pets, either directly or through drift. Do not allow adults, children or pets to enter the treated areas until sprays have settled. This product is corrosive to cotton fabrics.
PAGE 3
CHART 1 Application Rates Amount of this product per 1,000 Sq. Ft. Surface Area ________________________________________________________________________ Algae Type Planktonic Filamentous Chara ppm Copper 0.2 0.2 0.4 Average Depth in Feet 1 ft. 2 ft. 3 ft. 4 ft. 3.5 fl. oz. 3.5 fl. oz. 6.5 fl. oz. 6.5 fl. oz. 6.5 fl. oz. 13.0 fl. oz. 9.5 fl. oz. 9.5 fl. oz. 19.0 fl. oz. 13.0 fl. oz. 13.0 fl. oz. 25.5 fl. oz.
PAGE 4
HERBICIDE APPLICATION For rooted and submerged plants Control of many rooted and submerged plants such as Hydrilla and Potomogeton can be obtained from use of this product to give copper concentrations at 0.4 - 1.0 ppm. Choose the application rate dependent upon the density and stage of growth and the water depth from the chart below. Application Rates Fluid Ounces of product per 1,000 Sq. Ft. Surface Area Growth stage ppm Relative Density Copper (Low Density) Early Season 0.
PAGE 5
Calculate the drip rate of this product from the chart below (based on heavy algae growth). Water Flow Rate CFS Gal./Min. 1 450 2 900 3 1350 4 1800 5 2250 Product drip rate Qts./Hr. 1.8 3.6 5.4 7.2 9.0 ML/Min. 29 58 85 113 142 Fl. Oz./Min. 1.0 2.0 3.0 3.8 5.0 To maintain the copper level at 1.0 ppm for 4 hours, calculate the amount of this product needed by multiplying Qts./Hr., ML/Min., or Fl. Oz./Min. by 4. The chemical must be introduced at a point of turbulence.
PAGE 6
WARRANTY OF MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR PURPOSE. Purchaser’s and user’s sole remedy against Sanco Industries, Inc for any cause of action related to the handling or use of this product shall be for damages, the amount of which shall not exceed the price paid for the product that causes the alleged loss, damages, injury or other claim.
PAGE 7
Page 6 of 6 Pages
PAGE 8