User's Manual

TX: 7060
V-Mount
03
04
Structure & Interface
Antenna Interface
Antenna Interface Power Switch
Tally out
DC-IN
Transmitter Key Operation
Function
Operation Description
Code matching
Press the
“WPS/RTSP”
button for
about 3s
In the code matching process of the
transmitter and receiver, the word
“WPS” will always be displayed on
the OLED display, and the string will
disappear after the code matching.
The transmitter and receiver need to
be in code matching status at the same
time to achieve code matching.
Standard and
streaming mode
switching
Press the
“WPS ”
button for
about 6s
/RTSP
When switching to streaming mode,
the word “RTSP” will be displayed on the
OLED display, and the product will enter
streaming mode.
Restart the
encoding
board
Press the
“RESET”
button for
about 3s
During the restart of the encoding board,
the “RESET” string will always be
displayed on the OLED display of the
transmitter, and the string will disappear
after the restart.
LNA ON/OFF
WPS/RTSP
Reset
OLED Display
Network status
warning light
SDI In
HDMI In
RS232/422
SONY NPF Battery dock
Tips:in RTSP mode,the decoding
function is disabled
High-gain and
low-gain mode
switching
Hold the “LNA
on/off” button for
3 seconds to
switch the mode.
OLED without “L”
letter means
high-gain mode.
OLED with “L”
letter means
low-gain mode.
Line-of-sight scenarios:
TX-to-RX <200m/656ft: L(low-gain)
mode is recommended.
RX-to-LX >=200m/656ft: H(high-gain)
mode is recommended.
None-line-of-sight scenarios
(Human or wall blocking signal):
H(high-gain) mode is recommended.