Zero Latency Exquisite Design PRO 200 User Manual Model:7051+3051*2 Version:1.0 2018.07.
About the User Manual - Please read this manual carefully before you use this product and retain it properly for future reference. Contents - If there is any question or difficulty about the operation of product, please feel free to contact us or the dealer. About the User Manual 02 Brief introduction 02 Features 02 Packing list Specification Interface Information Quick Start Guide 03 04 05 09 - CVW reserves the authority to modify the instruction manuals.
Packing List Specification Please check the package inside to assure it contains the parts as below, if any parts missed, please contact the distributor or us. Transmitter Transmitter * 1 Antenna * 2 Power Cable * 1 2-Pin Lemo to D-Tap Hot-shoe Stand * 1 Specification Item Frequency Image transmission:5.1~5.9GHz Bandwidth 40MHz Video Formats 1080P 23.98/24/25/30/50/60 1080i 50/59.
Interface Information Transmitter Interface Transmitter Interface Description Model:7051 Specification Item 5.
Receiver Interface Model:3051 Receiver Interface Description 5.
TX Product Installation Transmitter Installation Steps: 1. Fix the antennas and adjust their angles as shown in the figure below. (For details, please refer to the transmission distance description.) 3. Turn on the power switch to start power supplying. Power Switch: ON turn on OFF turn off 4.Press “CH” button to select the corresponding working channel of receiver and then press “OK” button for confirmation.
RX Receiver Installation Steps: 3. Turn on the power switch to start power supplying. 1. Fix the antennas and adjust their angles as shown in the figure below. Power Switch: ON turn on OFF turn off Notice: please rotate the golden mental part of antenna to fasten the antenna. 2. Connect RX with the monitor via corresponding power cable and HD video cables as shown in the figure below. 4.
5. RX supports switching between normal mode and enhanced antiinterference mode according to transmission distance and interference level *To repeat 1~5steps if one more receiver is added a) Switch from normal mode to enhanced anti-interference mode: long press “OK” for longer than 3 seconds to enter enhanced anti-interference mode, and decimal point of digital tube (indicator) starts to flash slowly.
Receiver LED Digits Display description LED Digits Display: Channel 1 ~ 9, A, b LED Digits Display Status Video Indicator: HDMI and SDI outputs are enabled together, there are two status of the indicator 1:Red and Yellow light together: RX receives the signal from TX normally, and HDMI and SDI outputs are working together Power Indicator Video Indicator 2:No light: No output signals via HDMI and SDI ports Power Indicator: Flash slowly when the network is not connected.
Application Recommendations Application Recommendations In order to reach the best performance of wireless transmission, we recommend to meet the requirements as follows: 2.Recommended Installation Method under Non-ideal Position When the front side of the transmitter is not able to face to the receiver, Please make receiver to stand vertically; adjust antennas to a fan-shaped arrangement; 1. The vertical height of TX and RX should be same and more than 1.
Trouble shooting 3. Recommended Installation Method under Non-ideal Position Display“Link Connecting” When the front side of the transmitter is not able to face to the receiver, please try to adjust the direction of transmitter antennas to make sure that the formative fan-shaped arrangement can face to the receiver for best signal transmission. As shown in the right figure: Because TX and RX are working on ISM band, wireless transmission performance is relevant with level of interference intensity.
Audio Image displayed,No audio Video source mute Turn on the audio of video source Volume too low Turn up the audio of video source Audio format not supported Switch the format of video source output Something wrong with transmitter/ receiver Restart the transmission kit *For more questions, please contact the distributor or us.