Full Product Manual

19
1. Add a New Camera
2. Add IPC Repeater
1. First set the camera next to the NVR and
power up the camera.
2. Check the status light on the camera to con-
rm that it is in “Sync” mode, which is indi-
cated by rapid blinking.
3. Look for a button at the bottom of the
menu bar to add a new camera.
4. Click the “continue” button to start searching
for new cameras.
5. Wait for the NVR to automatically search for
cameras for 30 to 40 seconds. Once the search
is complete, your camera should appear in an
empty channel in the table on the right side
of the interface.
6. If the camera is successfully connected, click
the “continue” button to proceed. Check the
live view for the newly-added camera to con-
rm that it is connecting properly.
7. If you have issues with the live view, try re-
setting the camera to send it back into “Sync
mode” (see instruction for how to reset the
Camera), then initiate the search process
again.
TIP! - If you are replacing a camera, please
delete the camera from the connected device
rst, to make room for a new camera.
The IPC Repeater can be added to extend the
range of the camera by relaying the signal(Air
Bridge Function). If the Repeater came with the
system, it is already paired with the system, but
if you are adding an IPC repeater, you will need
to add the IPC Repeater by following the follow-
ing steps
When you are installing the cameras, please
consider the position of the camera on the
screen.
e.g.,
It is possible to change the channel assigned
to the camera by deleting it then re-adding it.
Front Gate
Garage
Front Porch
Backyard
VIIl. Adding a new camera & Air Bridge setup
IPC Repeater ( Model : CVTAR4S2 )
** Instructions for resetting Camera.
1. Reset the Camera, Press and hold the Re-
set/Sync button for
10 seconds
2. Wait for 40-50 seconds for the camera
to reboot. 3. Check the status light on
the camera to conrm that it is in “Sync”
mode, which is indicated by rapid
blinking.
If your IPC Repeater came with the system
kit, please skip the following.