External Power Supply Operation Manual for XP2i Digital Test Gauge
Contents Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Overview 3 —— Overview Introduction Although the XP2i was designed to operate for many hours on a set of 3 AA size batteries, there are times when even this may not be sufficient. For example, if your XP2i is mounted in a test stand, bench or panel, the battery access cover may be inconvenient, or even difficult to reach. To address these situations, Crystal Engineering has designed an external power supply that can be operated from virtually any available standard AC line supply.
—— Instructions 4 Instructions Installation Remove the (red) protective cover from DB9 connector on the back of the XP2i. (Save the cover—if you don’t need to use the RS-232 interface, you can use the cover to protect the DB9 connector on the computer side of the adapter). Connect the side of the DB9 pass-through connector with the captive screws to the XP2i (Figure 1). If the XP2i is to be permanently installed, screw the captive screws into the DB9 connector.
—— —— Specifications 5 Specifications Electrical AC Input Voltage ��������������������������������� 90 VAC to 264 VAC AC Input Frequency ��������������������������� 47Hz to 63Hz AC Input Current ��������������������������������� 0.5Arms (120VAC), 0.25Arms (240VAC) AC Inrush Current (Cold) ����������������� 30A max. (120VAC), 60A max.
—— —— Support 6 Support Contact Us Phone ��������������������������������������������������� (805) 595-5477 Toll-Free ����������������������������������������������� (800) 444‑1850 Fax ����������������������������������������������������������� (805) 595-5466 Email ����������������������������������������������������� crystal@ametek.com Web ��������������������������������������������������������� crystalengineering.
© 2013 Crystal Engineering Corporation 708 Fiero Lane, Suite 9, San Luis Obispo, California 93401-8701 3023.