User Manual

ManualsBrandsCrystal ManualsToolsWT Series Panel Mount Digital Pressure Gauge

Functions  3

XP2i Operation Manual

Functions

Units Button

Pressing this button causes the WT Series to select the next available unit of pressure measurement.

See Pressure Ranges, Display Scales, & Resolution on page 14 or the list of pressure units available for your model.

Units that you don’t need or never use can be turned o . You can also de ne a special unit for your WT Series with Con gXP.

You can use the WT Series to display directly in a unit not otherwise available, such as feet of seawater, or foot-pounds of torque. When you select your custom

unit from the keypad, the screen displays the USER icon.

Peak Button

Pressing the (peak) button causes the display to cycle through the following , depending on your setting in Con gXP.

<No Icon> . . . . Live Pressure display

. . . . Maximum detected pressure

. . . . Minimum detected pressure

(blinking)

. . . . PSV Mode, maximum

(blinking)

. . . . PSV Mode, minimum

. . . .

Average pressure

. . . . DataLoggerXP datalogging mode

* From the factory this setting is disabled. Use Con gXP to enable.

Peak High and Peak Low values are not saved when the gauge shuts o ; they will reset to the current reading when the WT Series is turned on or reset.

In some cases the ability to display a peak value may not be needed, or may even be dangerous. Con gXP allows you to disable this button.

The WT Series can average 1 to 10 readings, recalculated every time pressure is measured (4 times per second). Enable and set the number of readings to be averaged with Con gXP.

units

peak