User guide

VPS-2300 User Guide
4 Basic Software Setup
4.4 – Select Output Terminal
Using front panel control
1 Press SETUP button to start VP SETUP
2 Choose System Config, press OK to continue
3 Choose Output Select, press OK to continue
4 Choose DVI for digital device or RGBHV / YPbPr /
YCbCr / RGB(Cs) for analogue device
5 Press OK button to confirm
4.5 – Set Output Format / Resolution
Setting Output Format for Analogue devices
1 Press SETUP button to start VP SETUP
2 Choose System Config, press OK to continue
3 Choose Output Format, press OK to continue
4 Choose output format of the display device being
connected in the OUTPUT FORMAT menu
5 Press OK button to confirm
Setting Resolution for Digital devices
1 Press SETUP button to start VP SETUP
2 Choose System Config, press OK to continue
3 Choose Resolution, press OK to continue
4 Choose the resolution of your display device from
the list and press OK button to confirm
OR
5 Choose Preset Models, press OK to continue
6 Select the display device being connected
7 Press OK button to confirm
Congratulations! You have now completed the basic
configuration. In the following sections, there is much
more fine-tuning that you can do to fully optimize the
performance.
SETUP
OK
VP SET UP
Input Select
Aspect Ratio
Video Settings
Advanced
> System Config
AR Profile
Video Profile
Pixel Magic
SYSTEM CONFIG
Input Format
HD Active Wnd
> Output Select
Resolution
Output Format
H sync /V sync
Pre Y/C Delay
……
SETUP
OK
VP SET UP
Input Select
Aspect Ratio
Video Settings
Advanced
> System Config
AR Profile
Video Profile
Pixel Magic
SYSTEM CONFIG
Input Format
HD Active Wnd
Output Select
Resolution
> Output Format
H sync /V sync
Pre Y/C Delay
……
OUTPUT FORMAT
480p @59.94Hz
> 480p @60Hz
540p @60Hz
576p @60Hz
……
SETUP
OK
VP SET UP
Input Select
Aspect Ratio
Video Settings
Advanced
> System Config
AR Profile
Video Profile
Pixel Magic
SYSTEM CONFIG
Input Format
HD Active Wnd
Output Select
> Resolution
Output Format
H sync /V sync
Pre Y/C Delay
……
RESOLUTION
> Preset Models
800 x 600
848 x 480
856 x 480
……
PRESET MODELS
> Epson TW100
Fuj 1024x1024
Hitachi 40 Alis
InFocus 7205
……
OUTPUT SELECT
RGBHV
> DVI
YPbPr
YCbCr
RGB(Cs)
OUTPUT SELECT
> RGBHV
DVI
YPbPr
YCbCr
RGB(Cs)
TIPS: For optimum display, you should set
Crystalio to output a video signal that matches
your display perfectly in terms of resolution and
aspect ratio. See Section 5 Expert Configuration
for details on how to achieve this.