User guide

VPS-2300 User Guide
Position This setting allows the displayed image to be
moved to perfectly fit the display device.
Center
Crystalio will reset the image position to be
central on the display device
Customize
This allows fine manual control over the exact
image position (Use Navigation Buttons on the
front panel to set up)
Note: When initially pressing the arrow
keys, the image will move 30 pixels at a
time. If the same arrow key is held, the
movement will accelerate. Similarly if the
opposite key is pressed, the movement will
decelerate.
Crystalio automatically limits the position
function to ensure that the image is not
moved completely off the visible area
Crop The crop function allows areas of the displayed
image to be masked, useful if you do not want
part of the image to be visible on the display
device.
Crop Top
Crystalio will remove a section of the top area
of the image
Crop Bottom
Crystalio will remove a section of the bottom
area of the image
Crop Left
Crystalio will remove a section of the left area
of the image
Crop Right
Crystalio will remove a section of the right area
of the image
Use Navigation Buttons on the front panel to
set up
Note: When initially pressing the arrow
keys, the image will crop 30 pixels at a time.
If the same arrow key is held, the crop rate
will accelerate. Similarly if the opposite key
is pressed, the crop rate will decelerate.
Film Detect This defines the film mode detection window.
On some cases when the source has sub-title,
the de-interlacing method used may not be
correct. So, use this control for adjustment.
Normal Wnd
Uses whole image for detection
Small Wnd
Uses partial image for detection
Film Bias
Control
This can be set to a value ranging from 1 to 9,
with the smallest value suitable for most video
sources, while the greater values better suit film
sources.
NLS Config Non-Linear Stretching is used to fill a full 16:9
screen with a 4:3 image while minimizing the
widening effect on the image especially at
center of the screen. There are two parameters,
Center Shape and Crop to Fit, to stretch the
image according to personal preference.
Center Shape
This controls the shape of image in center area.
Setting of 3 makes the image look good at
center, but with more distortion at left and right
sides.
Setting of 0 produces a less non-linear
stretched image across the whole screen,
resulting in obvious distortion at the center of
the image.