Installation Sheet

ASSEMBLYINSTRUCTIONMODEL#2246-BF
CRYST
RAMA
WARNING:
ElectricalDanger
TurnPoweroff
WARNING: ThisproductcanexposeyoutoLead
whichisknowntothestateofCaliforniatocausecancer
and/orbirthdefectsorreproductiveharm.Formore
informationgotowww.P65Warnings.ca.gov
L I G H T I N GT H EW A YF O RS I X T YY E A R S
installedbyalicensedelectrician
inaccordancewiththeNational
Allelectricalcomponentsmustbe
ElectricCodeandtheappropriate
localelectricalcodes.
Howtoinstall
10.Installthebulbs(notincluded)intothesocket.
Youwillneed8-CandelabraBaseBulb
40WattsRecommended60WattsMax.
USELEDBULBSFOREXTENDEDUSE
This fixture is Dry rated
2.Slipthecenterrodassemblyalongwireandthread
intothecouplerlocatedonthetopofthelight
cluster.
5.Spreadthefixturearmsandarmringassemblyto
asuitableposition.
9.Installthefabricshadeontothecandlesleeve.
4”
6-1/2”
4-1/2”
LOOP
TOPCAP
46”
40”
6”
3/4”
FABRIC
SHADE
SCREW
NIPPLE
HEXNUT
COUPLING
COUPLER
UPPERCAP
LOWERCAP
FIXTURE
ARM
LOCKWASHER
NIPPLE
METALBOARDINSIDE
WITHSMALLHOLE
CENTER
ROD
CANDLE
SLEEVE
CHAIN
ARMRING
ASSEMBLY
METALBOARDINSIDE
WITHLARGEHOLE
168”
SPREADTHEFIXTUREARM
ANDARMRINGTOA
SUITABLEPOSITION
LIGHTCLUSTER
1 Removethetopcap,thenipple,thehexnut,the
coupling,andthelockwasherfromthecenterrod
assemblybylooseningtheloop.
.
3.Slipthetopholeofthearmringassemblyandlock
washeroverthenipplelocatedonthetopofthe
centerrodassembly,thensecurewiththecoupling.
4.Threadthenippleontothecouplingandadjust
Tightenitwithhexnut.
7 Removethetopuppercapfromthelowercap
assemblybylooseningthescrew.
.
6.Slipthetopcapoverthenipple,thensecurewith
theloop.
8.Putthelowercapthroughthebottomholeofthearm
ringassembly,securetheuppercapontothelower
capwiththescrew.