Installation Sheet

How to Install
All electrical components must be
installed by a licensed electrician
in accordance with the National
Electric Code and the appropriate
local electrical codes.
®
ASSEMBLY INSTRUCTION MODEL #ALX-4501-AG
This is a convertible piece. Installation steps for both
Hard-Wire and Plug-In options are below
4.75″
13.25
″
9
″
4.5″
14″
18.5″
5″
9″
25″
For Hard-wired installation, please proceed as follows:
1.Remove the plug wires from the fixture wires.
2.Remove the Nut (I) from the bottom of Back Plate (B)
and cover the hole with Plug (H).
6.Attach the Glass (E) onto Metal Cover (D) and secure
it with the Metal Spacer (F) and Socket Ring (G).
For Plug-in installation, please proceed as follows:
1.Connect Rod (J) to the bottom of Back Plate (B).
2.Determine the desired location you'd like to put
this fixture on the wall, and mark two points on
it with same distance as between the holes on
the Back Plate (B).
3.Drill the holes at the marked points and insert
the anchors into the holes in the wall.Attach
the mounting plate onto the wall by anchor screws.
4.Attach the Back Plate (B) onto mounting plate.
1″
WARNING: This product can expose you to Lead,
which is known to the State of California to cause cancer
and/or birth defects or reproductive harm. For more
information go to www.P65Warnings.ca.gov
You will need 1-Medium Bulb
60 Watts Recommended 100 Watts Max
Bulb not included
USE LED BULBS FOR EXTENDED USE
This fixture is damp rated
3.Determine the desired location you'd like to put
this fixture on the wall, and mark two points on
it with same distance as between the holes on
the Back Plate (B).
4.Drill the holes at the marked points and insert
the anchors into the holes in the wall.Attach
the mounting plate onto the wall by anchor screws.
5.Attach the Back Plate (B) onto mounting plate.
5.Attach the Glass (E) onto Metal Cover (D) and secure
it with the Metal Spacer (F) and Socket Ring (G).