Installation Sheet

How to Install
All electrical components must be
installed by a licensed electrician
in accordance with the National
Electric Code and the appropriate
local electrical codes.
WARNING: This product can expose you to Lead,
which is known to the State of California to cause cancer
and/or birth defects or reproductive harm. For more
information go to www.P65Warnings.ca.gov
®
You will need 6-Candelabra Bulb
60 watts Max Bulb not included
USE LED BULBS FOR EXTENDED USE
This fixture is DRY rated
ASSEMBLY INSTRUCTION MODEL #ELL-B3007-PN
1.Put the side covers onto the frame and secure with screws.
2.Attach the glass rods onto the frame and secure with nuts.
11″
7″
14″
48″
15.7″
5.Install the fixture onto the outlet box.
3.Screw the rods onto the frame.
4.Decide the preferred hanging height and choose the chain
needed.
Installation of safety cable
1.Feed wires and safety cable up through chain and the
hole of screw collar loop.
3.Feed safety cable through the cable lock and tighten it
with lock screw.
2.Continue to run safety cable through the top of outlet
box and secure it to the ceiling joist.
1.Place the mounting plate over the outlet box and mark 4
points on the ceiling aligned with the 4 holes on the
mounting plate.
2.Drill the holes at the 4 marked points.Insert the wall
anchors inside the holes.
3.Place the mounting plate over the outlet box and secure
it with 4 anchor screws.
Installation of mounting plate: